Controls; Remote Control - GEA AEW14 Manual Del Propietario Y Instrucciones De Instalación

Controls

Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for freezing outdoor conditions. It must not be used in freezing
outdoor conditions.
Features and appearance will vary.
Air Conditioner Controls
Power
Fan
NOTE:
setting the Set temperature or the Delay timer.
Power Pad
Turns air conditioner on and off. When turned on,
the display will show the room temperature.
Display
Shows the room temperature or time remaining on
the Delay timer. Shows the Set temperature while
setting the temperature in Cool or ECO modes.
The Set light will turn on while setting.
Temp Increase + /Decrease – Pads
mode. The Set light will turn on while setting.
Delay Timer Increase + /Decrease – Pads
Each touch of the Increase + / Decrease – pads
on the unit or the Increase + / Decrease – pads
on the remote control will set the delay time when
using the Delay 1–24hr timer. The Set light will
turn on while setting.
Fan Speed Pads
Auto on the unit. NOTE: On the remote control,
use the fan speed Increase + / Decrease – pads
to set the fan speeds to Low, Med or High
the Auto pad to turn Auto fan on.
NOTE: The default temperature reading on the display is degree Fahrenheit ( °F). To change the display to degree
Celcius (°C), press the Temp Increase + and Temp Decrease – buttons together and hold for 3 seconds. Repeat the
process to change back to degree Fahrenheit (°F)
4
Auto
High Cool
Med Fan
Low Eco
Delay
Mode Sleep
1-24 Hrs
Cool or ECO
Low, Med, High or

Remote Control

Fan
Mode Pad
Only mode.
Delay Pads/Delay 1-24hr Pad
Delay ON—When the air conditioner is off, it can
be set to automatically come on in 1 to 24 hours
at its previous mode and fan settings.
Delay OFF—When the air conditioner is on, it can
be set to automatically turn off in 1 to 24 hours.
How to set:
Press the Delay 1–24hr pad on the unit or the
Delay pad on the remote control. Each touch of
the Increase + / Decrease – pads on the unit or
the Increase + / Decrease – pads on the remote
control will set the timer in 1-hour intervals. The
Set light will turn on while setting.
To review the remaining time on the Delay 1–24hr
timer, press the Delay 1–24hr pad on the unit
Increase + / Decrease – pads on the unit or the
Increase + / Decrease – pads on the remote
control to set a new time if desired.
To cancel the timer, press the Delay 1–24hr pad
until the light on the Delay 1–24hr pad goes off.
Fan
49-5000084