Power Supply; Using The Alarm - Bigben Interactive RR30 Manual De Instrucciones

Power Supply

Connecting AC power
Plug the power cord into a standard AC outlet. When you connect AC power, the "00:00" will flash on the display.
Installing a battery
Installing a battery
To keep the clock running for up to eight hours during an AC power failure, insert a 9-volt battery(not supplied) in the
battery compartment. For the longest life, we recommend you use an alkaline battery.
Notes:
·The display does not light when the alarm clock radio is operating only on battery power but the clock time remains in
memory.
·A prolonged power failure can drain the battery.
Battery notes:
·Use only fresh batteries of the required size and recommended type.
·Dispose of old batteries promptly and properly. Do not burn or bury them.
·If you do not plan to use the alarm clock radio for a month or longer, remove the batteries. Batteries can leak chemicals
that can damage electronic parts.
Using your clock
Setting the clock time
Press once CLOCK SET and press HOUR to adjust the hour and press MINUTE to adjust the minutes until the correct
time is shown on the display. Press CLOCK SET once to confirm the time set.
Notes: The clock is shown in a 24 hour format.
12/24 hours display selection
Press and hold CLOCK SET for 5 seconds, display will be changed 12 hours or 24 hours.
Listening to the radio
Turning on the radio
Press ON/STANDBY once, the radio will be turned on.
Selecting radio band
Press BAND/MODE for selecting AM / FM radio band when RADIO is on.
Tuning to a station
Press and hold +TUNING- for 2 second, it will automatic search the next station.
Press
+TUNING- once to change the frequency up or down by 1 step to tune the station you required.
Turning off the radio
Press ON/STANDBY once, the radio will be turned off.
Refer to "using the alarm" for details.

Using the alarm

Your alarm clock radio has a dual-alarm system that lets you set two different alarm times.
Setting alarm time – when radio is STANDBY
9