Clatronic AKS 824 Instrucciones De Servicio/Garantía página 28

4....-05-AKS 824 20.07.2001 12:39 Uhr
Special Safety Instructions
• Do not vacuum liquids.
• Vacuum only dust and small crumbs. Do not vacuum sharp objects or hot
ashes.
Wall holder
Mount the wall holder with the supplied screws and dowels. To easily store the
accessories, you can mount the holder (no figure) laterally on the wall holder.
Charging the Batteries
Inserting the charging cable in the wall holder
After mounting the wall holder:
1. Pass the cable upwards through lower opening of the wall holder.
2. Hold the charger so that the rectangular part of the charger is located right in
front of the slot.
3. Press the charger in the slot. The charger must be connected securely. It must
remain in this position and it must not fall out when inserting or pulling off the
vacuum.
Insert the AC adapter in a duly installed 230V/50Hz protective contact socket. The
charging LED lights up. The charging lasts approx. 16 hours. Once the charging is
over, unplug the AC adapter.
Using the Device
Unplug the device and fit on the desired nozzle. To start vacuuming, shift forward
the ON/OFF switch. Once you have finished or when the batteries are down,
connect the vacuum to the charger as described in „Charging the Batteries". Make
sure that the plug is inserted.
Crevice nozzle: ideal for vacuuming corners and crevices, etc.
Brush nozzle: for soft fabrics like upholstery, car seats, curtains, etc.
Seite 27
Device start-up
Nozzles
GB
27