1.
Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the
device after its lifecycle could harm the environment. Do not dispose
of the unit (or batteries) as unsorted municipal waste; it should be
taken to a specialized company for recycling. This device should be
returned to your distributor or to a local recycling service. Respect the
local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing the Velleman! Please read the manual thoroughly before
bringing this device into service. If the device was damaged in transit, don't install or
use it and contact your dealer. Damage caused by disregard of certain guidelines in
this manual is not covered by the warranty and the dealer will not accept
responsibility for any ensuing defects or problems. Refer to the Velleman
Service and Quality Warranty on the last pages of this manual.
2.
Features
•
rotate the crank to charge the flashlight or your connected mobile hone
•
rotating the crank for 1 minute will give up to 60 minutes of continuous light
•
1x 1 W high-power LED + 2x Ø 5 mm LEDs
•
shockproof, waterproof to 10 m
•
modes: 2 LEDs/1 W LED/flashing 1 W LED
•
connections:
o 6 VDC input: for internal battery charging, with charging indicator (use external
charger PSSMV1, not included)
o 6 VDC output: for mobile phone charging, with charging indicator
•
comes with 5 connectors for Nokia (3.5 mm and 2 mm), Sony Ericsson, Motorola
V3 (mini USB), Samsung D828
3.
Use
Refer to the illustrations on page 2 of this manual.
Charging and using the Flashlight
Hold the flashlight firmly and rotate the crank vividly for 1 minute. Rotate until the
indicator turns green. Press the on/off button to use the flashlight: press once to
turn on 2 LEDs, press twice to turn on the centre LED, press thrice to turn on the
flashing LED, press a fourth time to turn off the flashlight.
The flashlight can also be charged using an external charger. Turn the protective
screw cap a quarter turn counter clockwise and remove it. Connect the charger
plug to the input connection. Disconnect when the indicator turns green.
Recommended charger: PSSMV1 (not included). Always place the screw cap back
when the input is not used.
25.08.2009
ZL388/9
USER MANUAL
3
Rev. 01
®
©Velleman nv