SHELF INSTALLATION INSTRUCTIONS
3. Use included wall anchors (AA) for drywall
installations only. If the wall type is other than
drywall such as Tile or Brick then use mounting
hardware appropriate for that wall type (not
included). Screw wall Anchors (AA) flush into
marked locations on wall. Pilot holes are not
necessary.
Note: Be careful not to disturb any water or
electrical lines that may be hidden in the wall.
Hardware Used
AA
Anchor
4. Place top plate of Wall Bracket (B) on wall so
holes in back of bracket align well with wall
Anchors (AA) already installed in wall. Use
Screws (BB) to secure top bracket plate to
wall. Repeat for both Wall Brackets (B).
Note: Be careful not to disturb any water or
electrical lines that may be hidden in the wall.
Hardware Used
BB
Screw
5. Locate bottom plate of Wall Bracket (B) and
Bracket Screw (C). Using a Phillips Head
screw driver (not included), screw bottom
plate of Wall Bracket back onto the Wall
Bracket top plate leaving a distance of
approximately 7/8" between the top and lower
bracket plates.
3
x 4
4
x 4
5
C
4
AA
AA
B
C
7/8 in.
B