Installation Instructions - Melchioni Family VERMENTINO NEW 12 Manual De Usuario

The temperature range for thermoelectric cooler is 12°C-18°C. When the temperature is set on
one certain point and the temperature inside reaches this point, the automatic temperature
control system begins to work and the cooling system goes into linear t emperature keeping
status .

6. INSTALLATION INSTRUCTIONS

Before using your thermoelectric cooler
• Remove the exterior and interior packing
• Check to be sure the following parts are included:
• Before connecting the appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Place your appliance on a floor that is strong enough to support the appliance when it is fully
loaded. To level your appliance, adjust the front legs at the bottom of the appliance.
• For recedes installation away from direct sunlight and sources of heat (stove, heater, radiator,
etc.).Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold or hot ambient temperatures may also cause the appliances not to
perform properly.
• The appliance is for indoor use only.
•
Allow 2 inches (5cm) of space between the cooler's side & wall and 4 inches (10cm) between back &
the wall.
Caution: Please keep the appliance away from substance, which can cause ignition.
Temperature
display
•
5 chromed shelves.
•
1 Instruction manual.
Temperature
Internal light
control
14