7. OPERATING YOUR THERMOELECTRIC COOLER
It is recommended that you installed the thermoelectric cooler in a place where the ambient
temperature is between 10-26°C .If the ambient temperature is above or below recommended
temperatures, the performance of the unit may be affected.
When the cooler works with full power, the two LEDs on the circuit board will flash. The red one
shows the power input status. The green one shows the output status of the cooling system.
Meanwhile the fan inside the cooler begins to work. When the door is opened, the light under the
temperature adjustor will turn on automatically.
The temperature range for cooler is 12°C to 18°C. When the temperature is set on one certain
point and the temperature inside reaches this point, the automatic temperature control system
begins to work and the cooling system goes into linear temperature keeping status.
Note: Wait 3-5 minutes before restarting if you unplug the cooler. The unit may fail to operate
properly if restarted too
8. CARE AND MAINTENANCE
Cleaners: Never use harsh, abrasive cleaners, heavy-duty cleaners, or solvents on any surface.
Exterior: Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains and for periodic
waxing, use silicon wax.
Cooler Section: Wash shelves and other removable parts in warm sudsy water, rinse and dry.
Wash interior with baking soda solution (3 tablespoons to I liter of water) or warm sudsy water,
rinse and dry.
Magnetic Door Seals: Wash with warm sudsy water.
The Finishing Touch: Replace all parts and return thermostat dial to desired setting.
Move the refrigeretor
• Remove all the bottles.
• Tape everything inside the thermoelectric refrigerator that could move.
• Lift the feet from the base so as not to damage them.
• Tap the door.
• Make sure that the thermoelectric refrigerator remains vertical during transport
quickly.
15