Assembling The Unit; Assembly Instructions - Sears CRAFTSMAN 316.292561 Manual Del Usuario

ASSEMBLING THE UNIT

Before operating, position the unit's handlebars.
NOTE: You may also need to reposition the roller height
before using the cultivator. Refer to the Adjusting
Tine Depth section.
Begin by carefully unpacking the contents and making
sure that nothing is damaged.
POSITIONING THE HANDLEBARS
1. Loosen the two knobs on the inside of the
handlebars (Fig. 1).
2. With the unit upright, swing the handlebars up into
the operating position (Fig. 1).
NOTE: Take care not to pinch the throttle cable or
switch wires when positioning the handlebar.
3. Tighten the knobs to secure the handlebars in place
(Fig. 2).
NOTE: Do not over-tighten the knobs.
4. Readjust the throttle cable and switch the wires so
they are smooth and tight against the handlebar
assembly. This will help prevent them from catching
or snagging during normal operation.
Handlebar
Knobs

ASSEMBLY INSTRUCTIONS

Handlebar
Knobs
Fig. 1
Hole
Bolt
INSTALLING THE TRANSPORT ROLLER
ASSEMBLY
If the roller assembly is not installed, or if you ever need
to remove or reinstall it, perform the following
instructions:
WARNING:
heavy gloves and a long sleeve shirt when
installing the roller assembly.
WARNING:
roller assembly must be installed when
operating the unit.
1. With the unit on its side, place the transport roller
assembly on the underside of the tine guard (Fig. 3).
Tine
Guard
Wing Nuts &
Lock Washers
Washer
Handlebar
Knob
Handlebars
Fig. 2
To avoid injury from
the tines, wear
To prevent serious
personal injury, the
Transport
Roller
Assembly
Fig. 3
7