FAAC XR4 433 C Guia De Inicio Rapido página 7

2) The LED (Fig.1 ref. ) relating to the pressed push-button flashes for the first 5 secs., and then flashes more quickly
for the next 5 secs.
3) The LED lights up on steady beam for 2 secs. and then goes OFF.
4) Release the pressed push-button when the relevant LED lights up on a steady beam.
5 FUNCTION LOGIC
You can command the receiver channels from different radio controls. (E.g.: radio control 1 commands
channel 1, radio control 2 commands channel 2, etc..)
CHANNEL
USCITA 1
OUTPUT 1 PULSE
OUTPUT 2 /
OUTPUT 3 /
OUTPUT 4 /
6 OUTPUT 4 ACTIVE TIME PROGRAMMING
If you give a pulse to channel 4 from the radio control, output 4 (closed contact) is activated for a programmable time varying
from a minimum of 1 sec to a maximum of 127.5 minutes.
To programme time, first of all select, with dip switch 2, the time base with which the board will count (see table fig.1); next press
the SW5 key (Fig.1 ref. ) until you reach the selected time (LED DL6 briefly lights up whenever the relevant key is pressed). Wait for
5 secs. without pressing any key, until LED DL6 lights up on steady beam for 3 seconds. (To exit programming)
EXAMPLE 1:
OUTPUT ACTIVATION TIME 4=5 minutes
1) Select 30 secs. time base
(Dip-switch 2 OFF )
2) Press key SW5 (Fig.1 ref.
(time base 30 secs. X 10 pressings = 5 min.)
3) Do not press any key for 5 secs. until you exit programming.
EXAMPLE 2:
OUTPUT ACTIVATION TIME 4=20 seconds
1) Select 1 sec. time base.
(Dip-switch 2 ON )
2) Press key SW5 (Fig.1 ref.
(time base 1 sec. X 20 pressings = 20 sec.)
3) Do not press any key for 5 secs. until you exit programming.
IF OUTPUT 4 IS ACTIVE, LED DL4 IS LIGHTED, WHEREAS LED DL6 FLASHES ACCORDING TO THE SELECTED TIME
BASE
SLOW FLASHING DL6
FAST FLASHING DL6
TO MODIFY OR CHANGE ACTIVATION TIME OF OUTPUT 4, REPEAT THE PROGRAMMING OPERATION.
PULSE FROM RADIO CONTROL
CHANNEL
2
DIP-SWITCH 1 OFF DIP-SWITCH 1 ON
/
CONTACT CLOSED
PULSE
/
) 10 times.
) 20 times.
30 SECS. TIME BASE SELECTED AND OUTPUT ACTIVE
1 SEC. TIME BASE SELECTED AND OUTPUT ACTIVE
3
CHANNEL CHANNEL
2
/
UNTIL NEXT PULSE
FROM REMOTE
CONTROL
/
/
CHANNEL
3 4
/ /
/ /
PULSE /
CONTACT CLOSED
/ UNTIL END OF
PROGRAMMED TIME