Assembly Instructions - Kobalt SGY-AIR171JH Manual De Instrucciones

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare
parts with package contents list and hardware contents list. If any part is missing
or damaged, do not attempt to assemble the product.
Esti mated Assembly Tim e: 20-30 min utes
Tools Required for Assembly (not included): Two open end wrenches (14mm, 13 mm)
Helpful Tools (not included): Phillips screwdriver, Hex key, Drill

ASSEMBLY INSTRUCTIONS

NOTE This product is already assembled before
it leaves factory. It can be mounted to a stable
surface directly with hardware (not provided).
However, it is recommended to take the following
steps for less fatigue in mounting hose reel to
a surface.
1. Disassemble bottom base (D) from reel
bracket (L) by using two open end wrenches
(not provided). (See Figure 1)
2. Mount bottom base (D) to a suitable location
on a bench, wall, ceiling, etc., by fitting proper
hardware (not provided) through three holes
of the bottom base (D). Make sure that the
bottom base (D) is mounted tightly and
securely. (See Figure 2)
NOTE
If you pre-drill, make sure not to drill a hole
deeper or larger than the screws (not provided)
which you would use to mount the bottom
base (D).
1
2
5