Important Information - Tena SmartCare Instrucciones De Uso

EN

IMPORTANT INFORMATION

• Ensure you have received training and/ or have read and understood
these instructions for use before using the product. Save these
instructions for use for future reference.
• The Change Indicator should be attached to the outside of the
incontinence product.
• The Change Indicator is not intended to be used in direct contact
with the skin.
• The same Change Indicator should never be used on more than
one resident.
• In the event of system failure or anticipated system failure,
revert to a manual changing routine.
• TENA SmartCare Change Indicator
• The system provides information on urine saturation levels to support
decision making regarding when TENA incontinence products should
be changed.
• TENA SmartCare Change Indicator does not replace normal safety
checks and routines for repositioning residents, checking for feces,
administering medication, etc.
• Do not attach the Change Indicator to the inside of the incontinence
product. TENA SmartCare Change Indicator should only be attached
to the outside of the incontinence product.
• If you encounter any problems, equipment failure or if any other
incidents occur, report them to the manufacturer or TENA
SmartCare support.
• The Change Indicator is intended for use with TENA incontinence
products.
• The adhesive strip for attaching the gateway will not adhere well to
dirty, dusty or oily surfaces and may not adhere well to vinyl surfaces.
Do not use tape on wallpaper, bare wood or on porous or painted
surfaces.
• Only a CR2032 battery should be used in the Change Indicator. Using
the wrong type of battery, including rechargeable batteries, can
damage the Change Indicator.
• Do not use gateways with unapproved power supplies.
is intended for 24/7 use.
TM/MC
4
TENA SmartCare Change Indicator
TM/MC