Paramount PARASCOPE Manual De Instalación página 6

Smooth Body Installation Guide
NOTICE: You can use regular PVC glue on smooth body
1. Make a cutout or opening approximately 1" deep and 1"
bigger than the pipe. This cutout will be filled with plaster
or other finish coat to create a water stop. (Fig. 12)
2. Cut off riser pipes flush with concrete surface. (Fig. 13)
3. Remove cap. Prime the inside of the pipe. DO NOT
PRIME THE BODY. (Fig. 14)
4. Glue the body into the pipe with a regular PVC glue. (Fig.
14) The glue must cover the full length of the body barrel
and 3" deep inside the riser pipe. Push the body into the
pipe until the shoulder hits the top edge of the pipe.
5. Let fumes vent for 30 minutes then replace all body
caps. (Fig. 15)
PLASTERING THE POOL
Leave all plaster caps in place for removal at start up. (Fig.
16)
NOTE: Optional, the plaster crew may remove the plaster
caps as they finish.
NOTE: The body does not come with the nozzle installed.
Fig. 12
For technical assistance call 1.800.621.5886 or contact your regional representative
CONCRETE DETAIL
6
Fig. 13
Fig. 14
Fig. 15
Fig. 16