Fig. K
13
Parking Foot (Fig. L)
Your planer is equipped with a parking foot
automatically lowers into place when the tool is lifted from
the work surface. When planing, the parking foot raises
as the tool is pushed forward. When the parking foot is
lowered, the planer can set on the work surface without the
blade touching.
CAUTION: Do not lock the trigger switch on and
engage the parking foot. The vibration of the running
motor will cause the planer to move, possibly falling
from the work piece.
Fig. L
Edge Chamfering (Fig. M)
Your planer has three precision machined chamfering
grooves 1.5mm, 2.0mm and 2.5mm
the front shoe
5
and are used for planing along a corner of
the material.
1. Adjust to desired depth of cut.
2. Place groove
17
over edge of material.
3. Apply weight to front of shoe
material edge.
4. Hold tool with both hands keeping pressure on front
handle
3
.
nOTE: It's a good idea to practice on a piece of scrap wood
before doing finishing work.
15
12
16
that
16
17
. They are located in
5
so groove is flat on
Fig. M
11
Drive Belt (Fig. N)
WARNING: Turn off and unplug the tool before making
any adjustments or removing or installing accessories.
To Replace Belt
1. Loosen the three screws
the belt cover
19
2. Remove old belt
3. Place new belt over front pulley
clockwise while pushing belt onto back pulley
4. Attach belt cover and securely tighten screws.
Fig. N
21
Accessories
WARNING: Since accessories, other than those
offered by PORTER-CABLE, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
PORTER-CABLE recommended accessories should be
used with this product.
A complete line of accessories is available from your
PORTER-CABLE Factory Service Center or a PORTER-CABLE
Authorized Warranty Service Center. Please visit our Web
Site www.portercable.com for a catalog or for the name of
your nearest supplier.
17
18
shown in fig. N and remove
.
.
20
21
then rotate belt
20
English
22
.
22
19
18
7