Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1. MEASURE OPENING
Wall
OPENING
The gate can easily be adjusted to accommodate openings from 38.3". to 72" as shown above".
If the opening is smaller than 72" you will need to angle the gate at the pivot points to fit the opening.
Installation
WARNING: When installing at the Top of the Stairs
•
Do not mount hinges into sheetrock or plaster. Hardware is included for use in solid materials only such as wood or metal.
•
Do not allow gate to swing over the stairs.
•
Place the gate in the opening so that the bottom of the gate frame is completely flat on the floor.
•
Do not angle gate towards the top of stairs.
2.WALL MOUNTING
First, take enclosed mounting template and cut on cutting line. Place template on both sides of opening.
FIGURE 1
Locate the mounting template vertical to the
floor and mark the screw holes.
Mount the upper and lower wall mounts
onto the wall or flat molding with screws included.
72"
Wall
-Follow steps 1-3 as illustrated below at both ends of the gate
Wall
FIGURE 2
Extend the folded gate.
Unfold the sides of the barrrier to fit in your space.
38.3"
Wall
OPENING
Page 3
Publicidad
Tabla de contenido
