Initial Setup - KlipXtreme Charme II KLS-651 Manual Del Usuario

Control
Use this button to activate the recording function when using the wired or
14. REC/Mic. Prio button
wireless microphone. Press it again to stop this function.
Insert a USB or SD™ drive and connect the microphone prior to start recording.
Double press the button to play the recorded file. Hold this button to delete the
recorded file.
This button also activates the microphone talk over feature. If enabled, it
prioritizes the microphone by silencing the music playback when there is an
announcement through the microphone. When this switch is o , the speaker
volume remains constant.
The LED light will turn red while charging and green when the unit is fully
15. Charging status
charged.
LED light
Adjust the volume level by turning this knob clockwise (to increase the volume)
16. Main volumen knob
and counterclockwise (to decrease the volume).
The volume can also be controlled directly from each of the sources connected
to the speaker.
Remote control
In addition to the panel controls, a remote control is included which provides additional functions to allow greater
control over the media player.
• Install the batteries in the remote control following the correct polarity as indicated inside the compartment.
(Requires two AAA batteries).
• In order for the remote to operate properly, ensure that it is pointed toward the front of the speaker.
1
16
9
8
3
6
11
12
Description
2
1 2 3
4 5 6
7 8 9
10
0
LIGHT EQ
7
RPT SCAN
6
VOL+
4
CH- CH+
5
VOL-
15
MENU TUNER
14
BT AUX USB/SD
13
Control
Press this button to put the speaker in Stand-by mode.
1. Power button
Mutes the audio coming from the speaker. Press it again to unmute the speaker in
2. Mute button
all modes.
In USB, SD™ and
3. button
In FM mode press it briefly to go to the previous channel or song.
In USB, SD™ and
4. button
FM mode press it briefly to go to the next channel or song.
5. button
Press to start and pause media during
6. Vol +/- button It increases or decreases the volume level of the speaker. The volume can also be
controlled directly from the sources connected to the speaker.
7. Scan button
In tuner mode, press this button to start scanning channels from the lowest up to the
highest frequency.
8. Repeat button
Use this button to repeat the current track or song only in USB and SD™ modes. It
has a single repeat or repeat all function.
9. Light button Press this button to turn ON/OFF the LED lights e ect.
10. EQ button
Scrolls through the di erent equalizer sound e ects.
11. Menu button Use this button to adjust the bass, treble, mic. vol., and echo e ects in the unit. When
this button is pressed the indications L-Bass, H-Treble, N-MIC Volume and E-MIC
reverberation will appear on the screen. Press the CH-/CH+ button to increase or
decrease the level.
12. BT button
Press it to enter the
13. Aux. in Connects a CD player, digital media player, a mobile phone or other audio source to
this 3.5mm stereo input jack.
Press it to enable audio playback from MP3 and WMA music files stored in a USB
14. USB/SD™ button
flash drive or SD™ memory card.
15. Tuner button
Press it to enter the tuner mode.
16. Numbered keys
In USB and SD™ modes, press any key from 0 to 9 on the remote to choose directly
the tracks you want to play. In tuner mode it allows the manual input of frequencies.
(0 to 9)
IV. Initial setup
Note: For your safety, read this manual and follow all safety instructions before using the product.
Charging the battery
1. There are two di erent ways to charge the battery:
a. Plug the supplied cable in the AC100-240VAC POWER IN on the
speaker and connect the other side to the wall outlet.
b. Connect the external battery to the DC12V IN speaker, according to the
diagram on the right. Note: External battery or cable are not included.
2. When the unit is not in use or switched o , it will automatically recharge the internal battery as long as it
remains connected to utility power.
3. When the battery is reaching a low voltage level (or discharges), the volume of the speaker output will be
reduced, and a warning tone will follow. The speaker needs to be charged at this time. Otherwise, it will shut
o .
Description
Bluetooth® mode press this button briefly to play the previous track.
mode press this button briefly to play the next track. In
Bluetooth®
Bluetooth® , SD™ or USB playback.
mode.
Bluetooth®
Speaker DC12V IN
12V
Battery