English - Philips HR 3610/15 Manual De Instrucciones

English

Important
• Read the instructions in conjunction with the illustrations before using the first time.
• Before you connect the appliance, check if the voltage specified on the appliance
corresponds to the mains voltage in your home.
• Never immerse any part of the appliance in water or any other liquid.
• Never put objects into the grille when the fan is connected to the mains.
• Keep a watchful eye on children. Never allow them to play with the fan.
• It is not advisable to expose people (especially babies and older people) to a continuous
cold air stream for a long time.
• Do not use the fan in very hot or humid environments, such as bathrooms.
• Keep the fan away from lace curtains, plants etc.
• Do not connect the appliance to the mains voltage unless completely assembled and
adjusted.
• If the mains cord of this appliance is damaged, it must only be replaced by Philips or their
service representative, as special tools and/or parts are required.
General description
A
Clip
B
Front grille
C
Hook
D
Blade cap
E
Fan blade
F
Plastic collar
G
Positioning holes
H
Rear grille
I
Oscillation knob
J
Positioning pins
K
Motor shaft
L
Motor unit
M
Sliding pipe
N
Extension release button
O
Fan stand
P
Mains cord
Q
Control Panel
R
Base opening
S
Fan base
T
Screws
U
Remote control unit (For model HR 3615 only)
Assembly
• Ensure that the product is not connected to the
mains when assembling.
- Insert the mains cord (P) through the base
opening (R) of the fan base (S).
- Put the fan stand (O) inside the fan base (S)
while pulling the mains cord (P) until it gives a
"click" sound. Avoid the mains cord being
pressed between the fan base and fan stand.
- Use a screwdriver to secure the fan stand with
(fig. 1, page 3) two screws (T) provided.
- Unscrew the blade cap (D) from the motor shaft
(K).
Please note: Unscrew clockwise.
- Remove the plastic protective tube from the
motor shaft (K).
- Unscrew the plastic collar (F) from the motor
unit (L) by turning the collar anti-clockwise.
- Mount the rear grille (H) onto the motor unit (L)
by matching the three positioning holes (G) on
the rear grille to the three positioning pins (J) on
the front of the motor unit.
Push in firmly until the three positioning pins
protrude through the three positioning holes.
- Secure the rear grille (H) to the motor unit (L)
with the plastic collar (F).
- Insert the fan blade (E) onto the motor shaft (K)
so that the flattened side of the central hole
corresponds with the flattened side of the shaft.
Press firmly until the fan blade stops.
Secure the fan blade with the blade cap (D),
turning anti-clockwise to tighten.
- Test fan blade (E) operation by rotating it with
your hand. There should be no friction with the
plastic collar (F).
If the blade does not rotate freely, disassemble
and repeat the procedures.
- Open the clip (A) by moving the clip
downwards.
- Attach the front grille (B) to the rear grille (H) by
positioning the hook (C).
- Join the two grilles by pressing firmly ("Click!").
- Secure the two grilles by moving the clip (A)
upwards.
- You can store excess mains cord under the fan
base (S) as illustrated in fig 2.
4