Philips HR 3610/15 Manual De Instrucciones página 5

Battery (for type HR 3615 only)
• The remote control unit (U) operates on one
CR2025 3V Lithium battery.
• A battery is supplied inside the Remote Control
Unit.
Please remove the paper cover before first use.
- Place the battery as shown in fig 8.
Ensure that the indication "+" corresponds to
the indication in the appliance.
• Do not leave empty battery in the appliance. If
you do not intend to use the appliance for a
considerable time, remove the battery.
Batteries contain substances which may pollute
the environment.
Please dispose of your old batteries at an officially
assigned place.
Height setting
- Press the extension release button (N) and pull
the sliding pipe (M) upwards or downwards to
the desired height (fig. 3).
• Lock the sliding pipe (M) at its lowest position
("Click") before moving the fan.
Oscillation
The fan will oscillate during operation when the
oscillation knob (I) is in the down position.
When the oscillation knob is in the up position, the
fan does not oscillate (fig. 4).
Free neck positioning
You can adjust the air stream direction in both
horizontal and vertical direction.
- Horizontally: Pull the oscillation
knob (I) upwards and turn the
motor unit (L) to the desired
direction (fig. 5).
In the same manner the area
through which the fan oscillates can be
adjusted.
You will hear a clicking sound while
positioning.
- Vertically: Move the motor unit (L)
upwards or downwards to alter the
vertical angle (fig. 5).
Control panel type HR 3610
(1)
(2)
1. Speed selection button
2. Timer setting button
3. Off button
Speed selection
- Press the "ON•SPEED" button once to switch
on the fan at high speed.
Pilot light "3" above the "ON•SPEED" button will
come on.
- Press the "ON•SPEED" button twice to switch
on the fan at medium speed.
Pilot light "2" above the "ON•SPEED" button will
come on.
- Press the "ON•SPEED" button three times to
switch on the fan at low speed.
Pilot light "1" above the "ON•SPEED" button will
come on.
Natural Wind
- Press the "ON•SPEED" button four
times for "Natural Wind".
Pilot light "1" will blink.
The fan will change speed at a random pattern,
producing comfortable natural wind.
• If you press the "ON•SPEED" button once
more, the fan will go back to high speed again.
You can change the speed during operation.
The other controls can only be used if the fan is
switched on (i.e. after pressing "ON•SPEED").
Timer setting
- Press the "TIMER" button once for automatic
switching-off after one hour.
Pilot light "1" above the "TIMER" button will
come on.
- Press the "TIMER" button twice for automatic
switching-off after two hours.
Pilot light "2" above the "TIMER" button will
come on.
- Press the "TIMER" button three times for
automatic switching-off after four hours.
Pilot light "4" above the "TIMER" button will
5
(3)