Midea FS40-14BU Folleto De Instrucciones página 12

ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled, that is
complete with its base and support and protection grid.
If in doubt, have the appliance checked or assembled by a qualified professional person.
For assembly, refer to figure.
Attention: always unplug the appliance before you assemble.
1) Remove the "L" screw and washer (1) from fixed rod.
2) Insert rod (4) into the base (3), inserting it into its seat, and lock it with the "L" screw
and washer (1).
3) Extend the adjustable rod (6) to the desired height and secure by tightening the fixing
rod fastening screw (5).
4) Remove the screw (8), place the handle (3) on
the body, so that the two ends and holes are
corresponding, and lock it with the screw.
5) Unscrew the fan attachment ring nut (17) on the motor shaft.
6) Remove n.4 screws (18) on the housing.
7) Insert the rear grid (19) onto the motor shaft, securing it using the 4 screws provided
(4.).
8) Insert the fan (16) on the motor shaft (20), so that the slot matches the spline. Lock
using the Fan attachment ring nut (17), (turning it counterclockwise to tighten).
9) Couple the front grid (15) with the rear grid (19) and lock with the retention hooks.
For safety reasons, you must ensure the fastening with the appropriate locking screw
(14) in the holes provided on the edge of the grid, (the screw holes must be in the
lower part).
10) Fix the "head of the fan" to the adjustable rod: press the two "pressure hooks" (2) in
the same time, insert the column inside of its seat in the fan head so that the two
hooks are inserted in the corresponding holes (7).
1) "L" screws
2) Spring
3) Base
4) Fixed rod
5) Spring holes
6) Adjustable rod
7) Safety screws
8) Screw
9) Handle
10) Clutch screw (up / down)
11) Motor housing
12) Oscillation button
13) Switch
14) Screw
15) Front grill/protective
screen
16) Fan
17) Fan fixing ring
18) Rear grill fixing screws
19) Rear grill
20) Motor shaft
12/32