Before Welding; Welding Helmet; Maintenance And Cleaning - BALDER SmarTIGer Manual De Instrucciones

For your protection and maximum efficiency, please read this informa-
tion carefully before use.

BEFORE WELDING

• Ensure that the helmet is correctly assembled and that it completely blocks any accidental
light. In the front, light may enter the helmet only through the viewing area of the autodarken-
ing welding filter.
• Adjust the headgear to ensure maximum comfort and to provide the largest field of vision.
• Check the prescribed shade level for your welding application and adjust your autodarkening
filter accordingly (see the table with recommended shade levels).
PRECAUTIONS
• Never place the helmet or the autodarkening welding filter on hot surface.
• Scratched or damaged protection screens should be regularly replaced by original BALDER
ones. Before using the new protection screen, make sure to remove any additional protection
foil from both sides.
• Use SmarTIGer only within the temperature range of -10°C to +60°C.
• Do not expose the autodarkening welding filter to liquids and protect it from dirt.
• Use only original BALDER spare parts. In case of doubt, please contact your BALDER author-
ized dealer.
• Failure to follow these instructions will invalidate the warranty. BALDER does not accept
responsibility for any problems which may arise from applications other than welding, or if the
instructions for use are not strictly followed. The SmarTIGer welding helmet is manufactured to
protect the welder's face against spatters and hazardous ultraviolet and infrared rays emitted
during the welding process. It is not intended to be used as a protection against impact, flying
particles, molten metals, corrosive liquids or hazardous gases.
• Materials which may come into contact with the wearer's skin could cause allergic reactions to
susceptible individuals.
• Welding helmet worn over standard ophthalmic spectacles may transmit impact, thus create a
hazard to the wearer.
• If the helmet and the protection screen both do not carry the B marking, then only the S mark-
ing is valid.
STORAGE
When not in use the filter should be stored in a dry place within the temperature range of -20°C to
+65°C. Prolonged exposure to temperatures above 45°C may decrease the battery lifetime of the
autodarkening welding filter. It is recommended to keep the solar cells of the autodarkening weld-
ing filter in the dark or not exposed to light during storage in order to maintain power down mode.
This can be achieved by simply placing the filter face down on the storage shelf.

MAINTENANCE AND CLEANING

It is always necessary to keep the solar cells and the light sensors of the autodarkening welding
filter free of dust and spatters: cleaning can be done with a soft tissue or a cloth soaked in mild
detergent (or alcohol). Never use aggressive solvents such as acetone. BALDER filters should
always be protected from both sides by protection screens (polycarbonate or CR39), which
should also be only cleaned with a soft tissue or cloth. If protection screens are in any way dam-
aged, they must be immediately replaced.
WARRANTY
The warranty period of SmarTIGer products is three years. Failure to follow these instructions
may invalidates the warranty. BALDER does not accept responsibility for any problems, which
may arise from applications other than welding.
4