Fitting Cable Glands; Drilling Information - Weidmuller Klippon TB MH Instrucciones De Montaje

Fitting Cable Glands

Drilling Information

The permissible areas for drilling are indicated in the table below. In each case if the
required ingress protection rating (IP) is stated on the certification label (ATEX or IECEx),
the stated IP rating must be maintained.
25
35
C
NOTICE
The permissible drilling area highlighted in the drawing above are the same
for an enclosure that is supplied either with or without a gland plate.
For enclosures that are larger than size KTB MH 765015 the drilling areas
on sides C & D are based on two separate glanding areas. The separation
area is 60mm. Note: Whether gland plates are fitted or not, this separation
area has to be taken into account!
12
A/B
d
i 35
A
B
25
25
F
D E
C/D
g 25
F