Clearing The Memory - STACK-ON QAS-1514-B Manual Del Instrucciones

OPENING THE SAFE USING YOUR
FINGERPRINT
To open the safe, press the scanner with a recorded
nger. e blue light will come on with one beep
(if the sound is turned on) and the scan will begin.
If the green light ashes twice with 2 beeps (if the
sound is turned on), the scan has been accepted
and the door will open.
If the red light ashes once, the scanner did not
read your ngerprint and you must try again. If the
red light ashes 3 times, the scanner read your
ngerprint and did not accept it.
If there are 3 rejected scans, where your
ngerprint was read, and the red light ashes 5
times with 5 beeps (if the sound is turned on),
you will have an automatic lockout for 60
seconds before you can try a scan again.
will beep one time (if the sound is turned on)
and the green light will ash once when the
lockout period is over.
If there is 1 more rejected scan where your
ngerprint was read and the red light ashes 5 times
with 5 beeps (if the sound is turned on), you will
have an automatic lockout for 5 minutes before you
can try a scan again.
the sound is turned on) and the green light will ash
once when the lockout period is over.
To close the safe, push the door closed until
locked.
TURNING THE SOUND OFF/ON
Your safe comes with the beep sound turned on.
To turn the sound o , press the scanner with a
recorded ngerprint for 10 seconds until the green
light ashes twice.
To turn the sound on, press the scanner with a
recorded ngerprint until you hear two beeps and
the green light ashes twice.
e safe
e safe will beep one time (if

CLEARING THE MEMORY

To clear the memory of all recorded ngerprints,
locate the reset bu on on the inside of the safe
and press this bu on for about 5 seconds until
the green light ashes 10 times with 10 beeps (if
the sound is turned on). All recorded scans will
be erased.
NOTE: For security you must record a
ngerprint. Failure to do so will compromise
the safety and security of the safe.
REMOVING THE SAFE FROM THE
MOUNTING BRACKET
Open the holster compartment as described in the
Installing the Ba ery section. When the holster
compartment has been released from the frame and
the L brackets have been rotated so they are at
against the back of the holster compartment, locate
2 nuts which are located in the bo om of the safe
body. Remove the 2 nuts and washers using your
ngers and li the safe o the tabs in the back of the
sleeve.
ere are some securing tabs on the mounting
sleeve that guide the back of the safe into position -
you will need to make sure you have maneuvered the
safe out of these tabs.
Thumb nuts
Mounting
Bracket
4
15
40667-1512