MAGICKWOODS Elements 49386 Instrucciones De Instalación

Questions? Call our customer service department at
1-855-995-5578, 8:30 a.m. - 5 p.m., EST, Monday - Friday
or e-mail: contactus@magickwoods.com.
PACKAGE CONTENTS
Base (x 1)
Faucet and drain not included.
WARNINGS & CAUTIONS
WARNING:
Two people are required for safe installation. Take extra
precautionary measures to ensure a secure grip on the vanity
base and top when lifting.
CAUTION:
• The bathroom floor and wall must be finished prior to
installation of the vanity base and top.
• Do not use water that exceeds temperatures of 140°F/46°C.
• Do not place any sharp or abrasive objects on the bare surface
of the vanity top.
INSTALLATION
1: Removing old vanity (if applicable): 1) Turn
off the water supply and take the drain out.
2) Disconnect the supply lines from the faucet.
3) Remove the old vanity top and vanity.
If the new vanity is not installed immediately,
temporarily stuff a rag into the drain pipe.
2: Using a level, locate any uneven floor
and/or wall areas where your vanity will be
installed. Unevenness can cause your vanity
to become misaligned resulting in twisting of
the cabinet. Repair any uneven areas by
reducing high spots or shimming low spots.
3: Provide sufficient protection on the floor to protect
the vanity from damage. Tilt the vanity backwards and
remove the shipping feet from the bottom of the vanity base using a pair of pliers (A - not included). Figure 1.
4: 1) Place the vanity in the desired position taking into account the location of your plumbing. 2) Ensure the vanity is level front to back and at
both sides.
5: Secure the vanity to the wall by inserting (x 2) #8 x 2" screws (C - not included) through the back rail of the vanity. Figure 2. It is
recommended that the vanity be installed to at least one wall stud. If you are unable to locate wall studs, it is recommended that you use
wall anchors (D - not included) to secure the vanity.
6: Attach the (x 4) knobs by using (x 4) 1" screws. Figure 3.
Top (x 1)
1" screws (x 4)
OVERALL DIMENSIONS (INCLUDING TOP):
36"W x 34"H x 19"D
91.44 cm W x 86.36 cm H x 48.26 cm D
EUROSTONE VANITY WITH TOP
INSTALLATION INSTRUCTIONS
Model 49386
PREPARATION
Tools required for assembly (not included):
• pliers (A)
• tape measure
• electric drill with #2 drill bit (B)
• level
Bumpers (x 4)
• (x 2) #8 x 2" screws (C)
• (x 2) wall anchors - if the vanity will not be
screwed to wall studs (D)
• silicone (optional) (E)
Knobs (x 4)
Estimated installation time: 2-1/2 hours
(including removal of old vanity if applicable)
CARE & MAINTENANCE
• To maintain the beauty of the furniture finish, avoid placing the
vanity in direct sunlight.
• Avoid exposing the vanity to extreme temperatures by installing
away from heat and air vents.
• Dust frequently with a clean, soft and dry cloth.
• Wipe away any water or liquid spills on the vanity base immediately
with a clean, soft and dry cloth.
• Clean the vanity top only with non-abrasive cleaners or mild
detergents - do not use powder cleansers. For extremely
stubborn stains, use a small amount of acetone on a cloth and
gently rub out the stain.
Figure 1
Figure 2