Manual Scanning; Reset To Factory Defaults; Channel Organising - Samsung LE32R7 Instrucciones Del Propietario

1.3 Manual Scanning
T o tune-in new channels and weak signals, the TV has been provided with the
option "Manual Scanning" where the channel data can be entered by the user.
After selecting the "Manual Scanning" from the Installation Menu, the following
screen will be displayed:
• Select the Channel Number.
You can select the specified channel you want to find.
The followings are defined as a default, but optionally you can choose it.
Signal Status bar shows you if it is valid.
• Input the frequency of the channel you want to find.
• Select the bandwidth. You can select the value of "6", "7" or "8" MHz.
• Select the Guard Interval Mode.
You can select the value of "AUTO", "/32", "/6", "/8", or "/4".
• Select the FFT (Fast Fourier Transform) Mode.
One of the values-"AUOT", "2 K", and "8 K"- will be selected automatically.
You may change the set value as your preference.
• After selecting option, press the enter/oK
1.4 Reset to Factory Defaults
T his is to restore the factory set values in case the user has encountered some
problems after changing any values of channel data and others which may be in error.
At the request window, if you press the enter/oK
factory default settings automatically.
This causes your previous settings to be deleted!
2. Channel Organising
T he "Channel Organising" menu has four functions:
The "Channel Organising" menu is used to delete the Frequencies and
Channels or Move&Edit Channel as you want.
• Enter the Pin Code.
If you have not entered your own Pin Code 0000 applies,
which was set at the factory.
O nce you have entered Pin Code, you do not have to input the code again
unless you turn the TV power off.
English-23
button to start the scanning process.
button, the TV will be reset to