Dyna-Glo DGPH901ATBR Instrucciones De Ensamblaje página 5

ASSEMBLY INSTRUCTIONS
4. Remove the cylinder housing and put it aside.
Lay the base assembly down on the floor. Attach
the three nail fixing brackets (E) to the base with
six M6X10 mm bolts (AA) and six washer Ø6 (CC)
as illustrated. Secure with six M6 nuts (BB). Tighten
with the wrench (DD).
Note: If this is your first time assembling the unit
with the table, begin the table assembly here.
If you disassembled a previously owned unit,
continue to add the table:
5. Slide the fastener (D) and table assembly
onto the post as illustrated. Do not tighten the
fastener (D) at this time.
Step 4
4
5
5
CC
BB
AA
E
DD
D