Eneral Notes On Safety; U - Purposes For Which It Is Intended; I Ncorrect Use; Ec Ce - SUHNER ABRASIVE LSA 79 Documentación Técnica

1. n
1.1 g

enerAl notes on sAfety

This operation manual is applicable for the machine LSA
79.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The tool is designed for grinding, milling, and deburring
metal, stone, and plastic with milling cutters and abra-
sives.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Otto Suhner GmbH of Trottäcker 50, D-79713 Bad Säck-
ingen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side)
complies with the requirements under the Directive
2006/42/EG. Applied standards: EN ISO 12100, EN ISO
11148. Document Agent: R Ackermann. D-Bad Säcking-
en, 07/2013.
R. Ackermann/Managing Director
2. c
2.1 P

rior to tAKing the mAchine into serVice

Use oiled compressed air (see also air quality un-
der section 2.3).
Observe national regulations.
2.2 t
AKing the mAchine into serVice
Before connecting the tool to the com-
pressed air supply set the rotary valve to
the «OFF» position!
The tool may be switched on only when the lock and at-
tachment have been installed correctly.
12
S
oteS on afety
ommISSIonIng
2.2.1 t /t
urn on urn off
Switch on the tool by turning in the direction of the arrow
to the stop. Turn back to switch off the tool. Before cutting
off the compressed air supply, always set the rotary valve
to the «OFF» position so that the tool cannot be reacti-
vated inadvertently.
2.3 r

Ating dAtA

Pressure
Power output
Air consumption full load EN ISO 15744
Air consumption at idling EN ISO 15744
Setting oiler idle
No-load speed
Max. wheel diameter
Collet chuck Ø
Sound pressure level EN ISO 15744 71.9dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight with hose
2.4 o

PerAting conditions

Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3. h
andlIng
3.1 t
ools
Observe the tool manufacturers instructions!
Only tools with a diameter of smaller than 10 mm may be
used.
max. 6.3bar
110W
3
0.29m /min
3
0.31m /min
1-2 drops/min
-1
77'000min
10mm
3mm / 1/8"
2 2
1.54m/s , K=0.65m/s
2/4/4
0.310kg
/o
peratIon