Bush Hog 3308-2 Serie Manual Del Operador página 101

TAILWHEEL INSTALLATION 3 POINT LIFT and SEMI
1. Place the height adjusting collar on the tailwheel beam.
2. Attach the height adjusting bracket to the base frame of the machine. Use two each 1/2" x 3-1/4" cap-
screws, 1/2" locknuts per bracket.
3. Place the tailwheel beam between the mounting lugs on the base frame and secure with 1/2" x 4-1/2"
capscrews and 1/2" locknuts.
4. With the tailwheel beam in the slot of the adjusting bracket, slide the adjusting collar to the bracket and
install with two 1/2" x 1-1/4" capscrews and1/2" locknuts.
5. Place the tailwheel through the pivot tube of the tailwheel beam and secure with spiral pin.
6 Apply Grease to pivot tube.
Tailwheel
Beam
Spiral
Pin
3308-2 SERIES 09/19
© 2019 Alamo Group Inc.
ASSEMBLY
MOUNT MODELS
DUAL TAILWHEEL BEAM ASSEMBLY
Height Adusting
Bracket
Height Adjusting
Collar
1/2" x 1-1/2"
Capscrew
1/2" x 3-1/2" Capscrew
1/2" Locknut
Tailwheel
Assembly
Assembly Section 3-7
Bushing
1/2" x 4-1/2"
Capscrew
1/2" Locknut
1/2" Locknut
Mounting
Lugs