Bush Hog 3308-2 Serie Manual Del Operador página 103

1. Remove Tongue assembly from shipping position and assemble to lower front holes of the hitch plates
(NOTE: be sure the pivot bushings remain inside the pivot tubes of the tongue.) Install the 1" x 8" cap-
screws through the tongue pivot tubes and secure with 1" locknuts.
2. Install the Leveling Rods to the tongue with the clevis that has the slotted holes. Place a 1" flatwasher
to each side against the slotted hole and insert the clevis pin. Secure with the 3/16" x 1-1/2" Cotter Pins.
3. Attach the Leveling Rods to the Axle Lugs with the Clevis Pin and two 3/16" x 1-1/2" Cotter Pins.
4. Place the Axle Arm assemblies to the Axle assembly and secure with (2) U-bolts per Axle Arm and (2)
3/4" Hex Nuts, 3/4" Lockwashers, 3/4" Flatwashers per "U"- Bolt.
5. Remove the Lug Nuts along with the Hub Cap Retainer. Install the Wheel assembly. Replace Hub Cap
Retainer on one of the lug bolts. Install the Lug Nuts and tighten.
6. Hose Holder is placed atop the hole in the plate between the Hitch Plates. Place a 1/2" Flatwasher on
top of the mounting loop of the Hose Holder and insert a 1/2' x1-1/2" Capscrew through the assembly
securing with a 1/2" Locknut to the underside of the plate.
3308-2 SERIES 09/19
© 2019 Alamo Group Inc.
ASSEMBLY
PULL MODEL ASSEMBLY
PULL MODEL ASSEMBLY
(Refer to Illustration on next page)
Assembly Section 3-9