Changing The Light Bulb; Troubleshooting; Disposal - Proline TTL 120 P Manual De Instrucciones

EN
Changing the light bulb
1. Set the thermostat knob to the off position (0) then unplug the appliance.
2. Remove the food.
3. Remove the screw that secures the light shield to the appliance.
4. Remove the light shield.
5. Unscrew the bulb and screw a new 15W (E14 base) bulb.
6. Attach the light shield to the appliance with the screw.
TROUBLESHOOTING
Before calling for service please check the following.
The appliance is not working.
Check the plug is inserted correctly into the mains socket.
Check there is power to the mains socket by plugging another appliance in, if the other appliance
works check the fuse in the plug.
The appliance is noisy when operating.
Check the appliance is level and it is not in contact with another appliance or kitchen furniture.
The appliance does not cool sufficiently.
If the door has been opened too often or it has been left open for a while it will take time for the
appliance to reach its set temperature.
Check the airflow over the rear of the appliance has not been reduced due to insufficient
clearance.
Check if a large quantity of fresh food has been introduced.
DISPOSAL
The refrigerating gas contained in the circuit of this appliance is isobutane (R600a); it causes a low level
of pollution but is inflammable. Please contact your local disposal department for advice on the correct
method of disposal.
9