CrimeStopper SP-102 Manual Del Usuario página 3

REMOTE PAIRING/ BATTERY REPLACEMENT
Pairing a Remote to the System
NOTE: Once you enter programming mode it will erase all of the other remotes paired to the
system, therefore we recommend having all remotes for the system ready to pair prior to
entering pairing mode. The SP-102 can pair up to 4 remotes. The Override/Programming button
can usually be found at the bottom of the dash near the OBD II port or near the driver's side fuse
panel. If you need help locating this button please contact the installation facility that installed
your security system.
1. Turn the ignition to the ON position
2. Press the Override/Program button 4 times. You will know you are in pairing mode once
the system "chirps" the siren and flashes the parking lights 4 times.
3. Once in pairing mode, press Button #1 or the LOCK/ARM button of the first remote you
want to learn. You will know that the remote has paired when the parking lights flash twice
indicating that the system is ready for the next remote. Now press Button #1 or LOCK/
ARM button of the next remote. The parking lights will flash 3 times indicating the system
is ready for the next remote. Continue this until you have added all of the remotes you wish
to add to control the system or up to 4 remotes.
4. After you have programmed all of your remotes, exit programming by turning the ignition
to OFF position.
Replacing the Battery
To replace the battery in the remotes you will need to remove the 4 screws on the back of the remote. Once all of the screws are
removed you can separate the remote. Now slide out the (3) CR-2016 batteries from the back of the circuit board. Stack the new
batteries on top of each other with the plus sign facing up and slide them into the holder on the circuit board. Place the remote pieces
back together and reinsert the screws holding the case together. Be careful to not over tighten the screws as it could strip out and not
hold the case together.
3
SP-102 4 BUTTON REMOTE
LOCK
UNLOCK
SILENT
TRUNK
RELEASE