CrimeStopper SP-102 Manual Del Usuario página 6

CARJACK MODES
NOTE: This feature will need to be enabled through the programming of the system. Consult the installation manual or installation facility
that installed your system.
Active Carjack - This feature provides Active Carjack protection and MUST be enabled before use through the alarm programming. To
activate, with the ignition ON, press Button #2 (UNLOCK). The parking lights will flash twice to confirm Carjack countdown has begun.
After 90 seconds the unit will begin the Carjack cycle consisting of pre-warning chirps for 20 seconds then turning into a full system
alarm activation with the siren and parking lights flashing for 5 minutes. To reset the Active Carjack, turn the ignition to the ON position
and press Button #2 (UNLOCK) again.
Passive Carjack - This feature provides Passive Carjack protection and MUST be enabled before use through the alarm programming.
To activate, the ignition has to be ON and a door must be opened. The parking lights will flash twice to confirm Carjack countdown has
begun. After 90 seconds the unit will begin the Carjack cycle consisting of pre-warning chirps for 20 seconds then turning into a full
system alarm activation with the siren and parking lights flashing for 5 minutes. To reset the Passive Carjack protection, turn the
ignition ON with the doors CLOSED, then press the Override/Program button 3 times.
Full-time Carjack - Full-time Carjack mode should only be used in extreme conditions. This feature provides Full-time Carjack protection
and MUST be enabled before use through the alarm programming. Every time the ignition is turned ON or a door is opened, the Carjack
countdown will be initiated. The parking lights will flash twice to confirm the Carjack countdown has begun. After 90 seconds, the unit
will begin the Carjack cycle consisting of pre-warning chirps for 20 seconds and then turning into a full system alarm activation with the
siren and parking lights flashing for 5 minutes. You MUST reset the unit every time the ignition is turned ON or a door is opened. To reset
the Full-time Carjack feature, the ignition must be ON and the doors must be closed, then press the Override/Program button 3 times.
NOTE: Before you are able to enter Valet mode, program any option or remotes, you MUST reset the unit every time the ignition is turned
ON or a door is opened when full-time Carjack mode is active. It is always active each time the ignition is turned ON and/or a door is
opened with the ignition ON.
6