Operation - Husky HOLC7218BB1MYS Guía De Uso Y Mantenimiento

Operation

Adjusting the height of the
1
wood top work surface
□
Insert the crank handle (K) into the shaft near the Husky
badge and align it in the hole until it is engaged.
□
To raise the work surface, turn the crank handle
counterclockwise to the desired height (38 in.-48 in.)
□
To lower the work surface, turn the crank handle
clockwise until it reaches the desired height or
rests back on top of the rolling cabinet.
□
When fully lowered, remove the crank handle and
place the crank cap back over the shaft.
□
To avoid damage, do not keep turning the crank handle once
it has rested on top of the cabinet.
NOTE: Some minor squeaking is normal when operating the crank.
WARNING: There is no storage in the center tray.
Use front and back trays only for storage.
Make sure the handle is in the proper position as the drawer
may interfere with the handle when you open drawer.
3
Removing the drawers
□
Fully extend and empty the drawer.
□ On the slide, lift up the plastic release lever on one slide
and push down the plastic release lever on the other slide.
Gently pull the drawer out so the slides can ride over
the stops.
K
7
2
Locking and unlocking the unit
IMPORTANT : The drawers must be fully closed before
locking / unlocking the unit.
□ To lock the unit, insert the key (I) into the lock (J) and turn
it one quarter turn counterclockwise. Then remove the key.
□ To unlock the unit, insert the key (I) into the lock (J) and
turn it one quarter turn clockwise. Then remove the key.
I
4
Installing the drawers
□ Pull the slides and slide carrier out until fully extended .
□ Hold the slide on the cabinet while aligning it with
the slide on the drawer.
□
Slightly insert one side and repeat for the other side.
□ Slowly push the drawer until it is fully closed to
engage the slide.
□ Open the drawer and close it to verify proper
operation.
Please contact 1-888-HD-HUSKY for further assistance.
HUSKYTOOLS.COM