Hoover IRONspeed Manual Del Usuario página 13

Ocultar thumbs Ver también para IRONspeed:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 92
Chapter 4.2 - Rinsing the Boiler for Scale Maintenance
In order to extend the life of your appliance, you should rinse the boiler to avoid
scale deposit in the boiler. You should rinse it every 2 months or on models
SRD 4106, SRD 4108, SRD 4110 and SRP 4105 wait that the "rinse" light (1e) flashes.
Models with "Rinse" Light
When the rinse light (1e) flashes, you should continue your ironing session normally.
Only remember to clean the boiler before use next time you plan to iron. Proceed as
followed:
Before going on, be sure that the appliance is cooled down and unplugged for at
least 2 hours.
Place the stand on the edge of your sink and place the iron on a flat surface. Remove
the calc removal cap (10). Unscrew the boiler rinse safety cap anti-clockwise with
a coin and remove it. Fill the boiler with 0,2 litres of tap water using a bottle and a
funnel. Shake the stand and then empty the boiler completely, filing out the water
in the sink. We recommend repeating this operation twice. Screw the boiler rinse
safety cap with a coin and put back the calc removal cap (10).
Next time you will plug and switch on your appliance, the rinse light (1e) will
continue flashing. Reset the appliance by pressing the rinse indicator and you can
start your ironing session immediately.
Models Without "Rinse" Light
Before proceeding, be sure that the appliance is cooled down and unplugged for at
least 2 hours.
Place the stand on the edge of your sink and place the iron on a flat surface. Remove
the calc removal cap (17). Unscrew the boiler rinse safety cap anti-clockwise with
a coin and remove it. Fill the boiler with 0,2 litres of tap water using a bottle and a
funnel. Shake the stand and then empty the boiler completely, filing out the water
in the sink. We recommend repeating this operation twice. Screw the boiler rinse
safety cap with a coin and put back the calc removal cap (17).
In any case, do not use any descaling products to clean or rinse the boiler.
Fig. 11: Cleaning Operation
12 -
13 13
GB
Ironspeeed_SR__1-15_union_pprod3.indd 12
11-12-2009 9:59:58

Publicidad

Tabla de contenido
loading

Tabla de contenido