Care And Maintenance; Troubleshooting - Twin Star DFH-CH-11-T Manual De Operación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SAFETY PROTECTION SYSTEMS
This product has protection safeguards that shut off the product when parts become
excessively hot or if it tips over. If the product shuts off, immediately turn the Control to
the "O" position and unplug it from the electric outlet.
If tipped over:
Place the product on a flat, level, stable surface in order to prevent the product from
tipping over again.
TIP: Always install and maintain at least one smoke detector in good operating condition
on each floor of your home. Periodically check and/or replace the battery in your smoke
detector with a new battery.

CARE AND MAINTENANCE

WARNING: Do not attempt to disassemble this product for any reason, as incorrect
re-assembly could cause a risk of fire or electric shock. Only qualified service personnel
should perform any servicing.
WARNING: Always unplug the product from the electrical outlet and allow it to cool
before cleaning or storing it.
NOTICE: This product is permanently lubricated at the factory before shipping and will
not require further lubrication for the life of the product.
Clean only the exterior surface by wiping with a soft, damp cloth, and allow the product
to dry completely before storing or using. Dust can be removed from any vents using a
small vacuum.
WARNING: Do not allow water or other liquids to enter the interior of the product.
NOTICE: Do not use abrasive cleaners/pads to clean the product.
To store, wind and secure the power cord using a twist tie or rubber band, and then
place the product in a cool, dry location.

TROUBLESHOOTING

PROBLEM
Your heater shuts off
unexpectedly or fails
to operate.
POSSIBLE CAUSE
1. No electric power.
2. One of the safety features
may have activated to
prevent overheating,
including the tip-over
safety switch.
1. Be sure the power cord is
plugged into a working
electrical outlet.
2. Check your thermostat setting.
The heater may be off because
it has reached the desired
temperature setting.
E-7
CORRECTIVE ACTION

Publicidad

Tabla de contenido
loading

Tabla de contenido