Installation - Glacier bay HD67553-014405 Guía De Instalación Y Cuidado

Installation

1
Installing the faucet assembly
CAUTION: Always shut off the water supply before removing an existing faucet or replacing any part of a faucet. Open the faucet handle
to relieve water pressure and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old faucet. Clean the mounting surface.
□
Unscrew the nut (D), and remove the washers (B & C).
1a
NOTE: This step is for ange installation (optional).
□
Before installation, ensure that the ange (F)
is placed on the bottom of the new faucet
assembly (A).
□
Insert the faucet assembly (A) through the hole
in the sink.
A
F
1b
NOTE: This step is for escutcheon installation (optional).
If the sink is uneven, use silicone under the gasket (H).
□
Before installation, remove the ange (F).
□
Ensure that the gasket (H) is pressed onto the
escutcheon (G) before the escutcheon (G) is
installed over the three holes in the sink.
□
Secure the escutcheon (G) to the sink using the
mounting nuts (I) provided. Hand tighten only.
□
Insert the faucet assembly (A) through the hole
in the escutcheon (G).
4
A
F
G
H
I
G