HoMedics enviraScape WFL-CANRUS Manual De Instrucciones Y Garantía página 4

WFL-CANRUS_A.qxd 11/10/06 2:48 PM
5. Set the fountain body onto the base so it sits level.
6. Slide each of the four clear side panels in to the
slots provided on the fountain body. (Fig. 4)
7. Place the fountain top on the fountain body so it
sits level. (Fig. 5)
8. Attach the A/C adaptor jack to the base power cord.
DO NOT plug into outlet at this time (Fig. 1).
9. Set the fountain on a level, waterproof surface.
10. Plug the power cord into a 120V household outlet.
The fountain & sound machine are controlled by
the switch on the power cord. If fountain doesn't
operate, rotate in-line switch once to turn "on" and
once more to turn "off". NOTE: Unit power must
be "ON" in order for both the fountain and sound
machine to operate.
11. To use sounds, press the sound button on the front
of the unit to begin playing the first sound. Continue
to press the sound button to toggle through the
three additional sounds. Note: A yellow indicator
light will appear on the button to indicate the
sounds are powered on. When you press the
sound button a 5th time, the sounds will turn off.
Note: The yellow indicator light will disappear on
the button to indicate the sounds are powered off.
1st Press: Sound Power On ("Dreamscape")
2nd Press: ("Wind Chime")
3rd Press: ("Mystique")
4th Press: ("Sunrise")
5th Press: Sound Power Off
12. The volume can be adjusted by turning the volume
dial to the right to increase volume and to the left to
decrease volume.
13. To turn fountain & sound machine completely off,
turn the main power switch on the cord. NOTE:
Main power switch must be used to turn unit
completely on or off.
- Fountain can be used independent of sound
machine
- Sound Machine can not be used without
fountain water flowing.
Page 7
Figure 4
Figure 5
Drip Loop
6
Maintenance
• To keep water clean:
Caution:
All servicing of this Periodically change water and clean the product
according to the water condition. Keeping the water
fountain must be per-
clean prevents the water from becoming sticky and
formed by
forming micro-organisms. We recommend distilled
authorized HoMedics
water to prevent mineral build-up.
service
• To clean off hard water deposits on the base:
personnel only.
Use a mixture of vinegar and water to clean and
remove any mineral build-up on the base and pump.
Attention:
Monthly maintenance will add to your pump's life.
In order to get best
• Keeping the water at an optimum level:
results, please oper-
Add water periodically to keep water level at an
ate pump completely
optimum level and to avoid shortening the life of
submerged
the pump. NOTE: Never let the pump run dry.
• Fountain Storage
Caution:
Unplug the fountain from the electrical outlet,
Always disconnect
empty the water, and store in a dry, cool place.
from electrical outlet
before handling the Troubleshooting
pump
• If the pump fails to operate, check the following:
Check the circuit breaker, or try a different outlet to
make sure the pump is getting electrical power.
Always disconnect from electrical outlet before
handling the pump. NOTE: Ensure that the
electrical cord loops below the electrical outlet
to form a 'Drip Loop' (Fig. 5). This will prevent
water from running down the cord into the
electrical outlet.
• If the pump gurgles, spews, or "burps":
Check the water level to make sure the pump
has enough water to function.
• Obtaining a desired water level:
Check the water level daily the first week to
measure the rate of evaporation; refill with
water as needed.
• If water is splashing outside the fountain:
Adjust the flow control valve to a lower setting on
the pump.
7