SANUS VuePoint FLT1 Manual De Instrucciones página 5

STEP 1 Attach TV Bracket to TV
1.1 Select TV Screw Diameter
Only one screw size fits your TV.
M6
M4 M8
01
NOTE:
If your TV
included inset spacers
or adapters, use them
UNDER the mount
hardware.
1. 3 Attach TV Brackets to Your TV
1
04
T
Position the TV brackets
04
shown - making sure the brackets are level.
IMPORTANT:
The tilt tension knobs
the outside edges.
1.2 Select TV Screw Length and Spacers
A
NO SPACER
• Flat Back TV
[TV brackets
lay flat on your TV]
Use short TV screws
Spacers
03
CAUTION:
washer , spacer
02
— Too short will not hold your TV.
05
T
and over your TV hole pattern as
05
T
should be oriented to
B
Use long TV screws
01
.
not needed. create extra space between the TV and TV bracket.
Verify adequate thread engagement with your screw
combination AND TV bracket
03 04
— Too long will damage your TV.
2
NO SPACER
A
Install using the screw combination
CAUTION:
DO NOT use power tools for this step. Tighten the screws only enough
to secure the TV bracket to the TV. DO NOT overtighten the screws.
SPACER NEEDED
• Flat Back TV
with
Extra Space Needed
[for deep inset holes
or cable interference]
and spacers
01
Inset Holes Cables
,
01
.
/ 05
B
02 01
03
A or B
Avoid potential personal injuries and property damage!
• Rounded or
Irregular Back TV
[TV brackets NOT
resting flat on your TV]
to
03
Rounded Back
SPACER NEEDED
02 01
you selected for your TV.
5