Location And Function Of Controls; Front - Sony PC-3000 Manual De Instrucciones

Location and Function of Controls

Front

1
9 8
1 1 1 1 1 1 /u u u u u (on/standby) button
To turn on the power, press 1 with the MAIN POWER
switch on the rear panel set to ON. The 1 button lights
in green. To turn off the power, press u. The u
button lights in red and the unit enters the standby
mode.
2 PROJECTOR INPUT SELECT buttons
Select the input signal of the connected projector.
VIDEO: Selects the video signal input from the
VIDEO or S VIDEO connectors and the audio
signal input from the AUDIO IN L/R connectors of
the projector.
To switch the video signal, use the SELECT
button.
SELECT (VIDEO/S VIDEO): Each time you press
this button, the input signal is switched between
the VIDEO and S VIDEO connectors.
A: Selects the audio and video signals input from the
INPUT A connectors of the projector.
B: Selects the signal input from the INPUT B
(optional Interface Board) connectors of the
projector.
C: Selects the signal input from the INPUT C
(optional Interface Board) connectors of the
projector.
3 Display window
Displays the names of the connected equipment, the
audio output level and other settings.
6
(EN)
2 3
7
4 CONTROL button
Press to display the setting item.
5 Arrow buttons (>/./?//)
Use to move the on-screen cursor or to make various
adjustments.
6 SET button
Press to set the each item of the CONTROL MENU or
enter the settings or adjustments of items in the
CONTROL MENU.
7 SELECT buttons
The number of each button indicates the position of the
signal interface board mounted on the rear panel.
To select the equipment to be monitored, press the
SELECT button which corresponds to the board to
which the equipment is connected. The button lights.
When the power is turned on, the button of the
previously selected board lights. Use the space around
the buttons for writing down the input source.
8 Remote control detector
Point the remote commander here.
9 SYS (system) SET button
Press to use a new system. Also, press this button to
recognize the system condition when the system or the
setting of the interface board is changed.
4 5 6