Zenith 35602SSTMP Manual Del Usuario página 9

9.
Insert plastic rings (AA) into the end of
the 1 in. diameter tubes (B). Insert the
end of the 7/8 in. diameter tube (A) into
the end of the 1 in. diameter tubes (B).
Extend the tubes to the proper length to
fit between the 1 in. mounting bracket (E)
and 7/8 in. mounting bracket (D).
Hardware Used
Plastic Rings
AA
10.
Fasten the 1 in. diameter tube (B) to the
1 in. mounting bracket (E) using threaded
sleeves (CC) and end cap screws (BB).
NOTE: Be sure to use Allen wrench (FF)
for threaded sleeves (CC) and end cap
screws (BB).
NOTE: Tighten set screws to level the rod
assembly use medium allen wrench (GG).
Hardware Used
Threaded Sleeve
CC
End Cap Screw
BB
Allen Wrench
FF
9
B
x 2
10
B
x 1
x 1
Medium Allen Wrench
GG
x 2
9
AA
E
BB
A
CC
x 1
IS35611