Connect Electrical; Install Duct Covers - General Electric MONOGRAM ZV830 Instrucciones De Instalación

6 CONNECT ELECTRICAL

Verify that power is turned off at the source.
WARNING:
and aluminum-to-copper connectors.
a strain relief.
•
•
• Secure all the connections with wire nuts on each
electrical connector.
the cover. Be sure the wires are not pinched.
• Secure the
screws.
Installation Instructions
the 6
12

7 INSTALL DUCT COVERS

• Place the decorative duct
covers on top of the hood.
NOTE: The inside duct piece
has vent holes on one end.
The holes are intended for
purposes. Slide the inside end into the outer
installation.
The inside duct piece must slip into the folded ends
of the outer section.
duct cover
duct cover
cover seat
•
Screw holes
• Press up on the front corners of the filter cover panel
cover to the hood.
screws
Duct cover
Duct attachment