Digital Tuner; Tuning To Stations - Philips EXPANIUM AZ 4000 Manual Del Usuario

Digital Tuner

Tuning to Stations

1 Press the POWER y button.
2 Press SOURCE once or more to select
TUNER (or press TUNER once on the
remote control).
Display: shows
by waveband, frequency and preset
station number if already stored.
3 Press FM/AM once or more to select the
desired waveband.
4 Tuning to stations: you can tune to your
stations manually or by automatic search
tuning:
Press SEARCH ∞ or § (or TUNING
5 , 6 on the remote control) and release
when the frequency in the display starts
running.
The radio automatically tunes to a station
of sufficient reception. Display shows
during automatic tuning.
Repeat step 3 if necessary until you find the
desired station.
To tune to a weak station, press SEARCH
∞ or § briefly and repeatedly until you
have found optimal reception.
12
briefly followed
Improving reception
– For FM, pull out the telescopic antenna.
Incline and turn the antenna. Reduce its length
if the signal is too strong (very close to a
transmitter).
Display shows
received in stereo.
– For AM the set is provided with a built-in
antenna so the telescopic antenna is not
needed. Direct the antenna by turning the
whole set.
5 To switch off the tuner, press POWER y.
Programming tuner stations
Store up to a total of 30 tuner stations in
the memory, manually or automatically.You
can also erase a preset station by storing
another frequency in its place.
Autostore
Automatic programming will start with a
chosen preset number. From this preset
number upwards, former programmed
tuner stations will be erased.The unit will
only program stations which are not in the
memory already.
1 Press PRESET / ALBUM - or + once or
more to select the preset number where
programming should start.
Note: If no preset number is selected, default
is preset 1 and all your presets will be erased.
stereo if FM station is