10-20X / 10-21X / 10-22X / 10-230
Read the complete manual before carrying out the installation and activating the system.
1. DESCRIPTION
This audio external unit from the Access Control Standard range is a standard part of a system with one or more internal units and a power supply. More
information on how the product is integrated into a complete system can be found in the technical catalogue.
The external unit is a flush-mounted unit and as such has an ultra flat and elegant appearance. Depending on the type ordered, the external unit has 1 to 30
bell push-buttons, arranged vertically in one, two or three columns. All types are described in the table under 'Technical data'. The external unit is provided
with an adjustable microphone and loudspeaker. All programming is stored on a removable EEPROM. It also has a continuously illuminated vandalproof
nameplate.
2. PARTS
Basic components
terminals with
removable connector
EEPROM memory
potentiometers for
loudspeaker and microphone
Additional accessories
The external unit is cabled with 2 wires for systems with 1 external unit and max. 20 internal units.
The external unit is cabled with 3 wires for systems with multiple external units or more than 20 internal units.
Also pay attention to the diameter of the conductors in the cable as it will determine the maximum distance that can be bridged between the power supply
and the external unit. To bridge greater distances, double pairs can be used.
Niko recommends the use of the following cables for installation of the external unit:
• Diameter 0.8mm (SVV, JYSTY, TVVF...): max. distance 250m
• Diameter 0.6mm (TPVF...): max. distance 150m
• Diameter 0.5mm (UTP, FTP, STP...): max. distance 100m
EN
flush mounting box
loudspeaker
opening for key
service unit connector
microphone
nameplate
name cards
fixing screws
19