Quick LDIM BUS RGBW Manual De Uso Y Mantenimiento página 13

DIMMER RGBW - REV003A
Serial communication cables
off
ON
on
SELECTIONS
The operating mode can be selected by DIP switch:
O
N 1 2 3 4 5 6
SELECT ADDRESS
6-position DIP switches for setting operating mode
Dip 1-3 = not enabled (reserved for other functions)
Dip 4 = Local/Remote mode
SELECT
Dip 5 = not enabled (reserved for other functions)
Dip 6 = type of light: white light/RGBW
ADDRESS Rotary switches for setting device address (max. 99 modules)
TLine DIP switch for connecting the load on the communication line in remote mode (last module)
SIGNALS
SIGNALS DIAGNOSTICS
LED INPUTS STATUS
On
n° 4+2
Off
LED OUTPUTS STATUS
On o Off
n° 4
Flashing
STATUS LED POWER IN - F1 e F2
On
n° 2
Off
STATUS LED CPU activity (ready)
Flashing
n° 1 Off
On
QUICK SPA
Use good-quality, twisted, shielded cables suitable for serial communication. Make
the connections following the information above.
TERMINATE THE LINE ON THE LAST MODULE OF THE NETWORK BY
TURNING THE Tline DIP SWITCH "ON".
ON
TLine
Enabled
Not enabled
Output
Output protected against overcurrents and short circuits
Power supply connected
No power supply or blown fuse
CPU active and power supply connected
No power supply or CPU blocked
CPU blocked
13
OPERATION / SIGNALS
Off = locale / On = local and remote
Off = white / On = RGBW
EN