Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION MANUAL
J
.P. SELECTA s.a.u.
CODE 80374 REV 0
6. Operation
CONTROL PANEL:
1. Adjustment (change between temperature / time)
2. Increase Value key
3. Reduce Value key
4. Stop button / Start cycle
STARTING UP:
1. Press the start switch and the screen will light up at the same time.
2. Press keys (2)/(3) until you select the desired temperature value in
the green display (the upper one).
3. Press key (1) if you want to select an operating time.
4. Press key (4) to start the cycle.
5. The heating symbol
6. Press the key (4) again to stop the process. Note: during operation,
the temperature or time adjustment value can be changed.
COMMENTS:
* Do not use the equipment at a lower temperature than ambient
+5ºC, because the thermostat might have difficulties in regulating
correctly.
* When using the time function, the green display (the upper one) will
indicate the remaining time. If you want to see the target temperature
value, press key (1).
* Before pressing the START / STOP key (4), make sure that the tem-
perature probe is connected to the equipment and mounted on the
point to be regulated.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
OCT/2018
(It can be modified without notice)
1
2 3 4
will light and blink.
Tel 34 937 700 877 Fax 34 937 702 362
Page: 10
Publicidad
Tabla de contenido
