Conversion Instructions - KENMORE ELITE 34562 Manual De Uso Y Cuidado

CONVERSION INSTRUCTIONS

Main Burner Conversion
The procedure for the 5 burner model is shown
here.
The procedure for the 4 burner and 3 burner
models is the same, except for the parts used:
For the 5 burner model, use the 5 Main Burner
Orifices that are marked "Use for 5B".
For the 4 burner models, use the 4 Main Burner
Orifices that are marked "Use for 4B".
For the 3 burner models, use the 3 Main Burner
Orifices that are marked "Use for 3B".
Before starting the conversion, make sure
all control knobs are in the OFF position,
LP tank valve is closed, and tank is
disconnected from regulator and removed
from grill. Next, open all lids and remove
warming rack, cooking grates, and heat
diffusers. (Fig. 1)
1. Remove the cotter pins at the back of main
burners to detach burners from bracket. (Fig. 2)
2. Lift back of main burners while sliding
burners out of firebox, disengaging main
burners from valves. (Fig. 3)
Fig. 1
Fig. 2
Back of Firebox
Fig. 3
Front of Firebox
4
Main Burner
Cotter Pin