R Eassembling The M Ask - ResMed ULTRA MIRAGE NV Manual Del Usuario

r M
easseMBlinG the ask
1
Insert the ports cap into the ports. Make sure the
tabs of the ports cap face away from the mask.
2
Insert the
elbow into the
mask frame
Elbow
and secure it
with the elbow
clip on the
inside of the
frame. The
flat side of
the elbow clip
must face the mask frame. If you have fitted the
elbow correctly, it should not move when you try
to firmly pull it away from the frame.
3
Replace the forehead pads by sliding the centre
division of the pads onto the forehead pad
holders.
Forehead
pad
4
Reconnect the forehead support to the mask
frame. Depress the tab and move the forehead
support into one of the four slot positions.
Elbow
clip
5
Fit the grooved edge of the nasal cushion to the
mask frame. Fit the top section first, then work
your way around the mask, pushing the cushion
onto the frame, ensuring a good seal has been
achieved. Push the cushion clip over the cushion
onto the mask frame, ensuring it clicks into place
in all locations.
Forehead
support
7