Raising The Panels Relative To The Roof Surface - DUALSUN M-60-3BBP Serie Manual De Instalación, Uso Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3.2.2 Raising the panels relative to the roof surface

It is necessary to ensure that the size of the hydraulic connections corresponds to the distance allocated by the laying
system, between the surface of the roof and the lower edge of the module frame, which will be in contact with the
mounting system.
Depending on the hydraulic nominal flow, two types of fittings have been designed. Their size at the rear of the module
is shown below.
The bulk of the hydraulic fittings on the rear side of the DualSun Spring panels is to be considered
carefully to avoid contact of the fittings with the surface of the roof cover.
Tie the interpanel links to the modules or to the rails of the mounting system in order to avoid them to
lay on the roof cover.
Please compare the following characteristics of the flexible hoses of the interpanel links with the allowable height:
Table 1 : Dimensions and bending radius of the DN15 and DN26 interpanel hydraulic links
Installation, operation and maintenance instructions - DualSun XXXM – 60 – 3BBP
DN15 fitting
Figure 9 : Overall dimensions of hydraulic connections on the rear panel
D
/D
(mm)
int
ext
Bending radius – R
DN15
15/21
(mm)
88
b
V1.2 – March 2020
DN26 fitting
DN26
26/32
140
Page 17 sur 41

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

M-60-3bbpn serieM-60-3bbpi serie

Tabla de contenido