N-Com MCS II Seguridad E Instrucciones página 16

Note: Carefully check the proper final positioning of the cheek pad, pulling
the chinstrap toward the inside of the helmet and testing the press-studs.
Caution: Make sure that there are no cables sticking out of the helmet and
that the loudspeakers are in their housing.
Caution: Always verify the proper length of the chinstrap and adjust it as
necessary, once again referring to the specific helmet instructions.
Fig. 24
16
Reposition the protection plate

covering the "N-Com" housing
on the shell. First insert the rear
part and then press the front
part until the fastening clasp
clicks.