Technical Data; Special Safety Instructions - DAY 72420 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
2-IN-1 BLENDER
Introduction
To get the most out of your new blender,
please read through these instructions
before use. Please also save the instructions
in case you need to refer to them at a later
date.

Technical data

Voltage/frequency:
Power rating:
Speeds:
Material:
With removable plastic jug and 600 ml Tritan
to-go-smoothie cup that can be placed
directly on the blender
The appliance is double insulated
and therefore does not require
earthing.

Special safety instructions

The blade on the blade unit is extremely
sharp. Never touch the blade with your
fi ngers.
Never allow fi ngers, hands or other objects
near the rotating blade.
Do not touch the rotating parts of the
blender.
Do not insert hands or utensils into the
blender jug during operation as this may
cause injuries or damage the blender.
Never place the blade unit on the blender
without correctly fi tting the blender jug or
smoothie cup.
Only use the blender to prepare foodstuff s.
220-240 V~ 50/60 Hz
300-350 W
2 + pulse function
PP plastic
Never use the blender for food that is hotter
than 80 °C. Be careful not to scald yourself
on any escaping steam when blending hot
foods.
Do not fi ll the blender jug or smoothie cup
above the MAX mark.
Do not run the blender for more than 1
minute at a time. Once the blender has run
5 times in 1 minute, allow it to cool down for
30 minutes before using it again.
The lid must always be on the blender jug
when you use the blender.
Wait until the motor has stopped before
fi tting or removing the blender jug or
smoothie cup.
Unplug the blender from the mains when
not in use. Never pull by the cord, but instead
grasp the plug and pull it out carefully.
Always place the blender on a fl at, stable and
dry surface.
The blender and cord must be kept away
from hot surfaces.
Never place the blender on or near an
electric or gas hob or in places where it may
come in contact with hot appliances.
If the cord for this appliance is damaged, it
must be replaced at a workshop specifi ed
by the manufacturer, as special tools are
required.
If the appliance itself is damaged, it must be
taken to a specialist for repair. If unauthorised
alterations are made to the appliance, the
warranty is void. Do not attempt to repair the
blender yourself.
Only use original accessories or spare parts.
The blender's motor unit must not be
submerged in water.
Do not use the blender to chop ice or other
very hard substances.
GB
18

Publicidad

Tabla de contenido
loading

Tabla de contenido