Jump Start Warnings - GENMAC OTTO Manual De Usuario

otto 8 in 1 emergency Kit
3� position the otto 8 in 1 emergency Kit so that you can see the pressure gauge�
4� Make sure the chuck lever is positioned up (away from the chuck opening)�
5� Remove the valve cap from the valve stem of the tire�
6� Attach the chuck to the tire's valve stem�
7� Move the chuck lever down to secure the chuck to the valve stem�
8� turn compressor switch on to "I" position�
9� Monitor the pressure gauge while inflating the tire�
10� When recommended tire pressure has been reached, turn off air compressor�
11� Disconnect hose and replace valve cap�
12� store the hose in the Air Hose Compartment�
13� Recharge the otto 8 in 1 emergency Kit as soon as convenient�

jUMp stARt WARnInGs

• this unit is capable of up to 600 Cranking amps which is enough to start a 4–6 cylinder
vehicle� It will not work on some larger 6-cylinder or larger vehicles�
• lead-acid batteries can release explosive gasses� failure to follow instructions
may cause property damage, explosion hazard, and/or personal injury�
• Do not smoke while jump starting�
• jump start a vehicle or boat in a well ventilated area�
• Do not attempt to jump start a frozen battery�
• Do not wear vinyl clothing when jump starting—friction can cause static
electricity sparks�
• Remove all metal jewelry—this can cause short circuits�
• Always use safety glasses when jump starting battery—acid can cause
blindness and/or severe burns�
• never allow red and black clamps to touch—this can cause power arcing
and/or explosion�
• After use, turn off power safety switch�
• Keep out of reach of children�
• excessive engine cranking can damage the vehicle's starter motor� If the engine fails to
start after the recommended number of attempts, discontinue jump start procedure and
look for other problems that may need to be corrected�
• If vehicle to be started has a positive Grounded system (positive battery terminal is con-
nected to chassis):
i� Connect negative (−) black clamp to vehicle battery's negative terminal�
ii� Connect positive (+) red clamp to vehicle chassis or a solid, non-moving, metal ve-
hicle component or body part� Do not clamp directly to positive battery terminal
or moving part�
14