Harbor Breeze 40308 Manual Del Usuario página 5

ASSEMBLY INSTRUCTIONS
2. Remove the three switch housing screws and
lower switch housing from the existing fan. If
applicable, disconnect the male and female plugs
located inside the switch housing (Fig. 2a).
Note: If your existing fan has a switch housing cap,
remove only the switch housing cap by removing
the switch housing screws at the bottom of the
switch housing (Fig. 2b).
3. Use a screwdriver (not included) to push out the
center cap from either the switch housing (Fig. 3a)
or the switch housing cap (Fig. 3b).
4. Remove the hex nut (AA) and lock washer (BB)
from the rod on the top of the light kit fitter (A).
Gently feed the wires from the light kit fitter
(A) through the hole in the center of the switch
housing (Fig. 4a) or switch housing cap (Fig.
4b). Thread the rod from the light kit fitter (A) into
the switch housing cap. Then thread the wires
through the lock washer (BB) and hex nut (AA)
and tighten the hex nut (AA) over the lock washer
(BB) to secure the rod.
Hardware Used
Hex Nut
AA
Lock Washer
BB
2a
Switch
Housing Plate
2b
Switch
Housing Cap
3a
3b
Switch
Housing Cap
4a
Switch
Housing
4b
Switch
Housing Cap
x 1
x 1
5
Center Cap
Center Cap
AA
BB
A
AA
BB
A
Lowes.com/harborbreeze
Motor
Housing
Switch
Housing
Motor
Housing
Switch
Housing
Switch
Housing